Specifications

18 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Disarming
The area can be disarmed if it is armed in any of the possible arming states explained in the previous sections.
For information on disarming an area using a card access reader or other special function refer to the Protege
Programming Manual.
y Access the area status display screen as explained in section Area Status Display (see page 15). Using the
scroll keys [Ï Ð] select the area that you want to disarm.
y From the Area Status screen, press the [DISARM] key to disarm the selected area. Pressing the [DISARM]
key starts the disarming process.
y When the disarming process is completed the area status will change to "disarmed".
*Area 001
is DISARMED
y Press the [CLEAR] key to exit.
i
To disarm the selected area, you must be able to access it, refer to the Area Security section (see
page 16).
24HR Enabling
The Protege System continually checks zones and trouble zones for a tamper condition regardless of the armed
status of the area. The 24Hr processing monitors trouble zones as well as tamper and shorts on zones within
the selected area. This allows the tamper zones to generate an alarm even if the area is disarmed. To enable the
24Hr processing of an area, you must have access to the area and the user must have the option to access the
24Hr Processing enabled.
y Access the area status display screen as explained in section Area Status Display (see page 15) . Using the
scroll keys [Ï Ð] select the area that you want to disarm.
*Area 001
is DISARMED
y From the Area Status screen, press the [Í] key to select the 24Hr Status screen.
*Area 001
24HR Disabled
y From the Area 24Hr Status screen, press the [ARM] key to arm/enable the 24Hr processing in the selected
area. Pressing the [ARM] key starts the 24Hr enable/arming process.
*Area 001
24HR Busy
y When the enable/arming process is completed the 24Hr area status will change to "24Hr Enabled".
*Area 001
is ENABLED
y Press the [Î] key to return to the area status display.
y Press the [CLEAR] key to exit.
i
To enable the 24Hr processing of the selected area, you must be able to access it, refer to the Area
Security (see page 16). The user must have the access 24Hr Processing Option enabled.
The Protege System protects the area programming by preventing ANY programming to be done
when either the Area or the 24Hr processing of an area is enabled. You must always disable the 24Hr
processing and disarm an area before the area can be programmed.