Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 179
Clipsal C-Bus Automation
To program the Clipsal C-Bus home automation service ensure that the service that has been selected is halted.
Press the [ENTER] key until the display shows the service type selection screen.
To operate the Clipsal C-Bus service you must connect a serial communications port using the PRT-COMM to a
C-Bus PCI (Personal Computer Interface) which allows a high level communication to be transported.
SV001 Ser Type
Clipsal C-Bus
Use the [1] and [3] keys to scroll the service types until you reach the Clipsal C-Bus home automation selection
and press [ENTER] to select the C-Bus home automation type displayed and proceed to the next
programmable option for the C-Bus home automation service. For more information about the list control data
entry refer to the section List Control Data Entry (see page 335).
Service Mode
The service mode determines how this service operates with the system controller. By default a service is set to
start with the operating system. Setting a service to "Start With The Operating System" (Start With O/S) allows
the service to operate automatically, if the system controller is reset or restarts. Manual control of the service
can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Communications Port Number
The communications interface port defines which serial port the controller will use for communication with the
Clipsal C-Bus PCI Interface. Select the communication port that will be plugged in to the PCI connection.
SV001 Port
Ext Port 1
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Communications Port Speed
The communications port speed defines the baud rate at which the Clipsal C-Bus service will operate. The
default value for C-Bus is 9600 bits per second. If the speed or configuration is different adjust this setting to
suit the C-Bus PCI configuration.
SV001 Speed
9600
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER] to select the speed
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).