Specifications

174 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
y Disabled the service will not log communication events.
Option 2 - Log DVAC Messages
y Enabled the service will log messages that are sent from the DVAC's network and store these in the event
log. Once again this will result in a large number of events being saved.
y Disabled the service will not log DVAC messages.
Option 3 - Respond All Call Command A
y Enabled the service will send an event if it has one ready when the DVAC's host requests an All Call A
command.
y Disabled the service will not respond to an All Call Command A.
Option 4 - Respond All Call Command B
y Enabled the service will send an event if it has one ready when the DVAC's host requests an All Call B
command.
y Disabled the service will not respond to an All Call Command B.
Option 5 - Respond All Call Odd/Even Address
y Enabled the service will send an event if it has one ready when the DVAC's host requests an All Call A
command and the device address is an Odd Address or if the requests an All Call B command and the
device address is an Even Address.
y Disabled the service will not respond to an Odd/Even All Call Command.
Option 6, 7 and 8 - Reserved
y Reserved do not modify
i
When setting the all call options in the data configuration for DVAC only enable one of the available
options. Setting more than one of the all call options will result in the first option that is set being used.
Miscellaneous Options
The miscellaneous options are current reserved.
SV001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 336).
Option 1,2,3,4,5,6,7 and 8 - Reserved
y Reserved do not modify
Area Group
An area group will define which areas this service will process when a reportable event is generated. An area
group of None (default) will result in all areas being sent with the service.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the area group selection and press [ENTER] to select the area group displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).