Specifications

170 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Report Count
The report count if set to a value other than 000 will restrict the service from sending more than the
programmed number of reports to the monitoring station. When using multiple reporting paths that potentially
can report the same event to 2 or more locations the report count should be programmed with an acceptable
limit (Between 8 and 16 is recommended).
SV001 Report
count: 000
To modify the report count (000 to 255, a setting of 000 will result in an unlimited number of reports being able
to be sent), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Handshake Time
The handshake time determines the time it takes for the remote receiving unit to answer and provide a
handshake message for the SIA format. By default this is set to 030 seconds and should only be adjusted if a
longer than normal call completion is required. When handshakes for lower speed formats are placed in front of
the SIA handshake it may be required to increase this time.
SV001 Handshake
time: 030
To modify the handshake time (000 to 255, a setting below 010 will result in the default of 30 seconds being
programmed), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Redial Time
The redial time determines inter phone number dialing timeout. A value of 20 seconds is programmed by default
meaning each phone number will be dialled with 20 second intervals from the time the previous call was
terminated.
SV001 Redial
time: 020
To modify the redial time (000 to 255, a setting below 010 will result in the default value of 030 being
programmed), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Off Hook PGM
The off hook PGM is activated when the service takes the telephone line and is deactivated when the service
completes communication. This PGM setting can be used with remote exchange systems that require ground
start communication connections.
SV001 Off Hook
pgm: --000:00
To modify the off hook PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
336).