Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 165
SIA Level 2 Reporting Service
To program the SIA level 2 reporting service ensure that the service that has been selected and is halted. Press
the [ENTER] key until the display shows the service type selection screen. The SIA service comprises of 3 levels.
The transmission of the information uses a line speed of 300 BAUD and requires a tonal acknowledge.
SV001 Ser Type
SIA (Level 2)
Use the [1] and [3] keys to scroll the service types until you reach the SIA level 2 reporting selection and press
[ENTER] to select the SIA level 2 reporting service type displayed and proceed to the next programmable option
for the SIA level 2 reporting service. For more information about the list control data entry refer to the section List
Control Data Entry (see page 335).
Service Mode
The service mode determines how this service operates with the system controller. By default a service is set to
start with the operating system. Setting a service to "Start With The Operating System" (Start With O/S) allows
the service to operate automatically, if the system controller is reset or restarts the service will automatically
restart with the operating system. Manual control of the service can be set by using the Manual option for the
service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
SIA Client Code
The SIA client code is used to identify the system to the remote monitoring company when a report is
generated. The client code will accept hexadecimal numbers however this will be dependent on the ability of the
receiver and should be verified before configuration.
SV001 Client
code: 000000
Type the appropriate 6 digit client code, after each digit you must press [Í] and [Î] to move to the next digit.
When the desired client code is entered, press [ENTER] to save the programmed setting and move to the next
screen. For more information about hexadecimal data entry refer to the section Hexadecimal Data Entry (see
page 335).
i
When using a 4 Digit Account code program the account code in the last 4 locations leaving the first 2
set at 00.
PABX Phone Number
The PABX phone number is dialed to gain an outside line if the system is connected to a internal phone
extension. The PABX phone number can also be programmed with a schedule in the case that between certain
times the phone line is directly connected with an outside line.
SV001 PABX
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 335).