Specifications
164 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Communications Port Number
The communications interface port defines which serial port the controller will use for communication when
sending the serial printer output.
SV001 Port
Ext Port 1
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Communications Port Speed
The communications port speed defines the baud rate at which the serial printer service will operate. The default
value for serial printer is 9600 bits per second. If the speed or configuration is different adjust this setting to suit
the host configuration.
SV001 Speed
9600
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER] to select the speed
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Communications Port Parity
The communications port parity defines the parity configuration for the communication with the serial printer. By
default this is set to None however can be adjusted to suit the needs of the host that is connected.
SV001 Parity
None
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to select the parity
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Area Events Group
The area events group defines which areas events will be sent through the serial printer service. Setting an area
group to None (Default) will result in all areas being sent. Setting an area group with a specific group of areas will
filter the area related events based on the areas configured in the group.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the available area groups and press [ENTER] to select the area group that is
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).