Specifications

160 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Service Mode 1
The service mode determines how this service operates with the system controller. By default a service is set to
start with the operating system. Setting a service to "Start With The Operating System" (Start With O/S) allows
the service to operate automatically, if the system controller is reset or restarts the service will automatically
restart with the operating system. Manual control of the service can be set by using the Manual option for the
service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Communication Port
The communication port defines the interface that this service will use to communicate with the Protege
Management Suite. TCP/IP or Serial (RS-232) ports can be used.
SV001 Port
TCP/IP 1
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
TCP/IP Port
The TCP/IP port defines the IP port that is used when communicating between the System Controller and the
Protege Management Suite. Ensure that both the controller and the PC software are configured to use the
same IP port. This parameter is only used when a TCP/IP port is selected as the Communication Port.
SV001 TCP/IP
port: 10000
To modify the TCP/IP port (00000 to 65535), use the keypad as explained in section Entering Decimal Numbers
(see page 333) and press [ENTER].
RS-232 Speed (Baud Rate)
When an external RS-232 serial port is selected as the communication port this parameter sets the baud rate
that is used.
SV001 Speed
38400
Use the [1] and [3] keys to scroll the available baud rates (150, 300, 1200, 2400, 4800, 9600, 19200, 38400)
and press [ENTER] to select the baud rate displayed. For more information about the list control data entry refer
to the section List Control Data Entry (see page 335).
RS-232 Parity
When an external RS-232 serial port is selected as the communication port this parameter sets the parity that is
used.
SV001 Parity
No Parity
Use the [1] and [3] keys to scroll the available parity and press [ENTER] to select the parity displayed. For more
information about the list control data entry refer to the section List Control Data Entry (see page 335).