Specifications

156 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Dialing Attempts
The dialing attempts determine how many times the dialer will attempt to dial a number before failure. This
setting will be overridden by the modem configuration dependent on the country of installation. For UL and ULC
installations this value can not be set above 8 and will be internally restricted if a value is programmed above this
value. The dialing attempts operates in conjunction with the dialing delay setting.
SV001 Dialing
attempts: 008
To modify the dialing attempts (000 to 255, a setting of 000 will result in the default of 8 attempts being used),
use the keypad as explained in section Entering Decimal Numbers (see page 333) and press [ENTER].
Port Open Attempts
The port open attempts determine how many times the service will wait for the modem to become available if
another service is already using modem for communication. This operates in conjunction with the port open
time settings.
SV001 Port open
attempts: 008
To modify the port open attempts (000 to 255, a setting of 000 will result in the default of 8 port attempts being
used), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press [ENTER].
Report Count
The report count if set to a value other than 000 will restrict the service from sending more than the
programmed number of reports to the monitoring station. When using multiple reporting paths that potentially
can report the same event to 2 or more locations the report count should be programmed with an acceptable
limit (Between 8 and 16 is recommended).
SV001 Report
count: 000
To modify the report count (000 to 255, a setting of 000 will result in an unlimited number of reports being able
to be sent), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Handshake Time
The handshake time determines the time it takes for the remote receiving unit to answer and provide a
handshake message for the contact ID format. By default this is set to 030 seconds and should only be adjust if
a longer than normal call completion is required.
SV001 Handshake
time: 030
To modify the handshake time (000 to 255, a setting below 010 will result in the default of 30 seconds being
programmed), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].
Redial Time
The redial time determines inter phone number dialing timeout. A value of 20 seconds is programmed by default
meaning each phone number will be dialled with 20 second intervals from the time the previous call was
terminated.
SV001 Redial
time: 020
To modify the redial time (000 to 255, a setting below 010 will result in the default value of 030 being
programmed), use the keypad as explained in section Entering Decimal Numbers (see page 333) and press
[ENTER].