Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 155
i
When using a service in Back Up mode the service should be programmed with the same area group
and account code as the service it is backing up. In some cases it may be desirable to program a
different account code for the back up service. Consult with your Monitoring Station Operator to
ensure you correctly configure the back up service.
y Disabled the dialer will operate as a normal service and report alarms as programmed.
Option 2, 3, 4, 5, 6, 7 and 8 - Reserved
y Reserved do not modify
Miscellaneous Options
The miscellaneous options allow you to program special functions and features for the contact ID service.
SV001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 336).
Option 1 - Log Modem Service Events
y Enabled the service will provide step by step event information showing the call progression and detailed
logging information. This option can be turned on for diagnostic purposes but should not be enabled as
large volumes of events are stored.
y Disabled the dialer will not log events.
Option 2, 3, 4, 5, 6, 7 and 8 - Reserved
y Reserved do not modify
Area Group
An area group will define which areas this service will process when a reportable event is generated. An area
group of None (default) will result in all areas being sent with the service.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the area group selection and press [ENTER] to select the area group displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).
Reporting Table
With the size of the Protege system the maximum reporting points available in the Contact ID format is easily
exceeded, to allow flexibility a reporting table has been created to allow information to be sent using pre-defined
zone numbers or values. There are 2 predefined configurations for the reporting tables and 8 custom tables that
can be configured for use by any of the services. For information on the custom tables refer to the Table
Configuration section (see page 282).
SV001 Reporting
Table 000
Use the [1] and [3] keys to scroll the reporting tables selection and press [ENTER] to select the reporting table
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).