Specifications

152 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Contact ID Client Code
The contact ID client code is used to identify the system to the remote monitoring company when a report is
generated. The client code will accept hexadecimal numbers however this will be dependent on the ability of the
receiver and should be verified before configuration.
SV001 Client
code: 0000
Type the appropriate 4 digit client code, after each digit you must press [Í] and [Î] to move to the next digit.
When the desired client code is entered, press [ENTER] to save the programmed setting and move to the next
screen. For more information about hexadecimal data entry refer to the section Hexadecimal Data Entry (see
page 335).
PABX Phone Number
The PABX phone number is dialed to gain an outside line if the system is connected to a internal phone
extension. The PABX phone number can also be programmed with a schedule in the case that between certain
times the phone line is directly connected with an outside line.
SV001 PABX
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 335).
Phone Number One
The primary phone number will be dialed by the contact ID service when it first is initiated to report an event. The
sequence of telephone number dialing is limited by the number of dialing attempts and the method of dialing
that is configured (alternate or sequential).
SV001 Phone 1
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 335).
Phone Number Two
The secondary phone number will be dialed by the contact ID service if a connection with the central station can
not be made on the primary phone number. This may be dialled after the total number of attempts is reached on
the primary or sequential until the total number of attempts is reached for the primary and secondary numbers.
The sequence of telephone number dialing is limited by the number of dialing attempts and the method of
dialing that is configured (alternate or sequential).
SV001 Phone 2
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 335).