Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 139
Use the [1] and [3] keys to scroll the schedule selection and press [ENTER] to select the schedule displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).
If a schedule is selected and no secondary door type is programmed all doors that are assigned this door type
will not function when the schedule becomes invalid.
Secondary Door Type
The secondary door type is used in conjunction with the schedule to allow a door to have a secondary
configuration when the schedule that is assigned is invalid. This allows different modes of control over the
method a user access the door. For example between 8am and 12pm the user can be required to access the
door with only a card however outside these hours a card and pin is required.
DT001 Schedule
None
Use the [1] and [3] keys to scroll the secondary door type selection and press [ENTER] to select the door type
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 335).
Reader Entry Operation Mode
The reader entry operation mode determines how an entry reader that is associated with the door that has this
door type assigned will operate. There are four possible modes that can be set to allow the use of card, card
and pin, card or pin and pin only to operate.
DT001 Read In
Card Only
Use the [1] and [3] keys to scroll the reader in modes and press [ENTER] to select the mode displayed. For
more information about the list control data entry refer to the section List Control Data Entry (see page 335).
Anti Pass Back Entry Operation Mode
The reader anti pass back operation mode determines how an entry reader controls the ability for a user to pass
back their card or details for another person to gain access while they are already inside a protected area. The
Protege System use's global anti pass back per controller.
Selecting soft pass back will allow the user entry however it will log an error in the buffer that a pass back
violation has occurred. Selecting hard pass back will prevent the user from gaining entry and also log an event.
DT001 Pass In
None
Use the [1] and [3] keys to scroll the anti pass back modes and press [ENTER] to select the mode displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 335).
Reader Exit Operation Mode
The reader in operation mode determines how an exit reader that is associated with the door that has this door
type assigned will operate. There are four possible modes that can be set to allow the use of card, card and pin,
card or pin and pin only to operate.
DT001 Read Out
Card Only
Use the [1] and [3] keys to scroll the reader in modes and press [ENTER] to select the mode displayed. For
more information about the list control data entry refer to the section List Control Data Entry (see page 335).