Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 133
Pre Alarm PGM Pulse OFF Time
The pre alarm PGM pulse off time is used to make the PGM output pulse on and off when activated. The value
entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit off
for 1 second and then on for the programmed time set in the pulse on section.
DR001 Pre Alarm
time: 000 off
To modify the pre alarm pulse off time (000 to 255 100ms Increments), use the keypad as explained in section
Entering Decimal Numbers (see page 333) and press [ENTER]. Both the on and off pulse settings must have a
value greater than 000 for this feature to operate.
Left Open PGM or PGM Group
You can assign a PGM or PGM group that will activate when the maximum open time that is programmed is
reached indicating that the door has been left open. Use this to tell users that the door must be closed
immediately and that the system has generated an alarm.
DR001 Left Open
pgm: --000:00
To modify the left open PGM or PGM Group, use the settings as explained in section Entering PGM and PGM
Groups (see page 336).
Left Open PGM Pulse ON Time
The max open PGM pulse on time is used to make the PGM output pulse on and off when activated. The value
entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit on
for 1 second and then off for the programmed time set in the pulse off section.
DR001 Left Open
time: 000 on
To modify the left open on time (000 to 255 100ms Increments), use the keypad as explained in section Entering
Decimal Numbers (see page 333) and press [ENTER]. Both the on and off pulse settings must have a value
greater than 000 for this feature to operate.
Left Open PGM Pulse OFF Time
The left open PGM pulse off time is used to make the PGM output pulse on and off when activated. The value
entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit off
for 1 second and then on for the programmed time set in the pulse on section.
DR001 Left Open
time: 000 off
To modify the left open pulse off time (000 to 255 100ms Increments), use the keypad as explained in section
Entering Decimal Numbers (see page 333) and press [ENTER]. Both the on and off pulse settings must have a
value greater than 000 for this feature to operate.