Specifications

118 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Armed PGM or PGM Group
You can assign a PGM or PGM group to activate whenever the area completes the arming cycle. The armed
PGM or PGM Group will be deactivated when the area completes the disarming cycle. Use this to drive local
indicators on keypads, card readers and relays for signaling that the system is armed.
AR001 Armed
pgm: --000:00
To modify the Armed PGM or PGM Group, use the settings as explained in section Entering PGM and PGM
Groups (see page 336).
Armed PGM Pulse ON Time
The armed PGM pulse on time is used to make the PGM output pulse on and off when activated. The value
entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit on
for 1 second and then off for the programmed time set in the pulse off section.
AR001 Armed
time: 000 on
To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in section Entering
Decimal Numbers (see page 333) and press [ENTER]. Both the on and off pulse settings must have a value
greater than 000 for this feature to operate.
Armed PGM Pulse OFF Time
The armed PGM pulse off time is used to make the PGM output pulse on and off when activated. The value
entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit off
for 1 second and then on for the programmed time set in the pulse on section.
AR001 Armed
time: 000 off
To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in section Entering
Decimal Numbers (see page 333) and press [ENTER]. Both the on and off pulse settings must have a value
greater than 000 for the pulse output to operate.
Disarmed PGM or PGM Group
You can assign a PGM or PGM group to activate whenever the area completes the disarming cycle. The
disarmed PGM or PGM Group will be deactivated when the area completes the arming cycle. Use this to drive
local indicators on keypads, card readers and relays for signaling that the system is disarmed and can be
entered. This can also be used for interlocking non reader controlled doors to prevent entry to areas if the area
is armed. Use this output in conjunction with user area's to control multiple storage lockers or storage facilities.
AR001 Disarmed
pgm: --000:00
To modify the Disarmed PGM or PGM Group, use the settings as explained in section Entering PGM and PGM
Groups (see page 336).