Specifications

110 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE
Option 5 - Inverted Operation
y Enabled the PGM will operate inverted. Deactivation will result in the PGM being activated and activation will
result in the PGM being deactivated.
y Disabled the PGM will operate normally.
Option 6 - Activate On Module Power Up and Reset
y When enabled the PGM will activate when the module powers up, this will be overridden by the current
state that is held in the controller.
Note that these options are different from the activation and deactivation settings in the miscellaneous
section as they relate to the local module PGM's.
y Disabled the PGM will be deactivated by the module at power up.
Option 7 - Control PGM Communications Failure
y Enabled the PGM will be controlled and set to the state that is programmed in the communications state
setting Option 4.
y Disabled the PGM state will not be modified during a module communication failure.
Option 8 - Communication State Setting
y Enabled the PGM will be activated if option seven is enabled.
y Disabled the PGM will be deactivated if option seven is enabled.
PGM Extra Options
Extra options are currently reserved.
CP001:01 Extra
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 336).
Option 1, 2, 3, 4, 5, 6, 7 and 8 - Reserved
y Reserved do not modify