Specifications

PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 107
Option 6 – Toggle Zone Control PGM On Restore
y Enabled the zone control PGM will be toggled when the zone goes in to alarm. You can use this option to
activate a PGM on alarm and deactivate on the next alarm. This is ideal for lighting control and automation
applications.
y Disabled the zone type takes no action on the zone control PGM.
Option 7 and 8 - Reserved
y Reserved do not modify
Reporting Code
Each zone type has a default reporting code already assigned which determines the code that is sent to the
central station when an alarm is generated refer to the
Contact ID Codes table . However, it is possible to
change the reporting code of the zones to which this zone type is assigned. This is used when using special
reporting formats for example ModBUS Remote uses this to identify special zone points to the remote Protege
System Controller.
ZT001 Report
code: 255
To enter a reporting code (000 to 254), use the keypad as explained in section Entering Decimal Numbers (see
page 333) and press [ENTER]. By default the Zone Type Reporting Code is set to 255. Setting a value of 255
uses the default reporting code for the zone assigned.
Control PGM or PGM Group
You can assign a PGM or PGM group to activate whenever a zone type process's an alarm or restore for a
zone. The zone type must have the control PGM options set in the PGM options.
ZT001 Control
pgm: --000:00
To modify the PGM or PGM Group, use the settings as explained in section Entering PGM and PGM Groups
(see page 336).
Control PGM Activation Time
You can override the programmed activation time for a PGM by setting an activation time in the zone type.
ZT001 PGM on
time: 00000 secs
To modify the PGM or PGM Group, use the settings as explained in section Entering PGM and PGM Groups
(see page 336).