Installation manual

3.0 Mounng

The Protégé® EliteSuite® Eclipse LED Keypad maintains complete control of your residence.

All the acons performed in your security system will be executed through the Protégé® EliteSuite®

Eclipse LED Keypad. It is intended to be mounted on a wall.

Step 1

Select where to mount the Protégé® EliteSuite® Eclipse LED Keypad.

Step 2

Remove the rear half of the Protégé® EliteSuite® Eclipse LED Keypad by depressing the retaining

clip and rotang the case halves apart.

Step 3

Hold the rear case half against the wall and mark the mounng holes and cable entry area.

The cable entry area should align with a hole cut through the plaster wall-board. Cables are

intended to be run inside the wall. Use appropriate screws (not supplied) to ax the case to the

wall.

Step 4

Run the wiring. Refer to later secons of this manual for the electrical connecons. Leave about

20cm (8”) of wire protruding through the center of the mounted half of the case.

Step 5

Connect the wiring to the Protégé® EliteSuite® Eclipse LED Keypad electronics, then, to clip the

case together, hook the top edges together then rotate and press the boom in unl you hear the

clip snap into place.