Installation manual

DisplayOpons

The display opons are not relevant to and not used by the Protégé® EliteSuite® Eclipse LED

Keypad.

ArmingOpons

ReporngOpons

Opon Descripon

Fast Arming Enabled When enabled, the system can be FAST ARMED by pressing and

holding the Arm key.

Fast Stay Arming Enabled When enabled, the system can be FAST STAY armed by pressing

and holding the Stay key.

Fast Instant Arming Enabled When enabled, the system will allow the Stay key to be pressed

and held during the exit delay of a stay arming cycle to allow the

stay arming to be changed to an instant arm.

Fast Force Arming Enabled When enabled, the system can be FAST FORCE armed by pressing

and holding the Force key.

Opon Descripon

Report Arming/Disarming When enabled, the Protégé® EliteSuite® Eclipse LED Keypad will

send a message to the system controller when the system is armed

or disarmed. If this opon is disabled the current status of the

Protégé® EliteSuite® Eclipse LED Keypad will not be valid. It is

recommended this and the Report Alarm opons are always

enabled.

Report alarm Acvaon When enabled the Protégé® EliteSuite® Eclipse LED Keypad will

send a message when an alarm occurs on the EliteSuite® System.

This also enables the sending of the alarm silenced and alarm

med out messages.

Report Zone Bypassed When enabled, the system will report when the EliteSuite system is

armed with zones that have been bypassed.

Report Zone Fault When enabled, the system will report any zone fault trouble

condion to the system controller. This will not indicate the zone

that has the fault as this will be shown on the local keypad and in

the trouble view menu.

Report User Menu Access When enabled, the system will report when the master user has

accessed the main menu.

Report Local Installer Access When enabled, the system will report when the local installer code

is used to gain access to the local installaon opons.

Report Extended Informaon When enabled, the system will report extended informaon such

as the device tamper and re loop trouble condions. These

condions do not generate an alarm in the system locally but can

be used to generate an event at the local monitoring or remote

monitoring centre alerng the operator to a potenal problem.