Installation manual

14.0 Conguraon via Protégé®

14.1ConnecngtotheModule

Before aempng to connect to the module please ensure that:

• Your system controller has condominium rmware version 7.XX or above.

• It has an ‘Apartment’ prole loaded.

• ‘Controller used for Condominiums’ is checked under the Controller Properes.

• It is online and communicang with the Protégé® Soware.

Step 1

Select the ‘Controller’ tab (top level on the screen) and select ‘Condominiums’ (second level

icons).

Step 2

Select the ‘Programming (Condominiums)’ tab from the top of the Condominiums secon.

Step 3

Right click on ‘Condominium ##’ where ## corresponds to the address that was set on the module.

Step 4

Select ‘Properes’ from the pop up window.

A pop up box will appear which will show the progress while uploading the current sengs from

the controller. If this box does not appear and the Condominium # Properes window appears

immediately then the soware is not communicang with the controller.

Step 5

Once the upload is 100% complete click on ‘Close’ and the Properes window will open. The

following secons describe the various tabs of the Condominium # Properes window.