Installation manual

13.0 Zones (Menu 3)

The eight zones of the Protégé® EliteSuite® Eclipse LED Keypad can be individually congured as

one of seven zone types and can have specic opons assigned to them. The secons Selecng a

Zone, Zone Type and Zone Opons are intended to be followed one aer the other in order to set

up a zone.

13.1SelecngaZone

Step 1

To enter the Zone Number selecon menu enter the following key press sequence:

, 3,

Step 2

Select the zone which you wish to view or alter by pressing the number key corresponding the

desired zone. When the number key is pressed the number LED will stay lit to indicate the

selecon.

Step 3

Press the ENTER key ( ) to conrm your selecon.

13.2 Zone Type

Once you have selected a zone, (refertosecon13.1) you must select the Zone Type.

Step 1

Select the Zone Type by pressing the number key corresponding the desired Zone Type. When the

number key is pressed the number LED will stay lit to indicate the selecon.

Step 2

Press the ENTER key ( ) to conrm your selecon. Pressing the MENU key ( ) will abort the

operaon without saving any changes.

You must select a Zone Type from the following list:

Zone Types

1 Disabled Zone is disabled, does not funcon in the system.

2 Delay Zone will have an entry delay when a user enters.

3 Follow

Zone will not cause an alarm if the entry delay has started otherwise the zone will be an instant

zone. Use this to set the Zone Type for a moon detector that is located in an entrance area.

4 Instant Zone will cause alarm immediately.

5 24hr Zone will always cause an alarm immediately.

6 Fire Zone is a re zone and will generate and instant alarm.

7 Fire Delay

Zone is a delayed re zone and will generate the re delay beeping and require the user to follow

the delay re zone procedures to prevent a full re alarm from being acvated.