Installation manual

12.0 Opons (Menu 2)

12.1GeneralOpons(Menu2,1)

The General Opons set opons that relate to the general operaon of the Protégé® EliteSuite®

Eclipse LED Keypad.

Step 1

To enter the General Opons menu enter the following key press sequence:

, 2, 1

The currently assigned values will be displayed using the number LED’s.

Step 2

To toggle opons press the keys 1 to 8, and the corresponding number LED will be lit when that

opon is enabled.

Step 3

Pressing the ENTER key ( ) will save the opons. Pressing the MENU key ( ) will abort the

operaon without saving any changes.

The available opons are:

Opon 1 - Zone Type Opon 1

If Duplex Zone (Opon 2) is not enabled then Opon 1 will set the Zone Input Conguraon (EOL

or NO EOL). EOL requires the use of 2x 1k resistors to provide, Short, Alarm, Closed and Tamper

monitoring. NO EOL provides alarm and closed monitoring.

• Enabled, EOL resistors are used (2R Mode) (2 zones).

• Disabled, NO EOL resistors are used (2 zones).

Opon 2 - Duplex Zone Operaon

If Opon 2 is set Opon 1 does not have any funcon. When Opon 2 is set the zones will use a

1k and 2k4 resistor and provide monitoring for 2 zones.

• Enabled, Duplex Zone Mode (4 zones).

• Disabled, Opon 1 sets the zone conguraon.

Opon 3 - Beep On Trouble Condion

• Enabled, the beeper will emit 2 beeps every minute if a trouble condion is present, to silence

the trouble beep, view the trouble condion.

• Disabled, no trouble beep will be generated.