Installation manual

10.0 Local Installer Login

The default Local Installer code is [0000].

Step 1

To access the Local Installaon menu enter the following key press sequence:

, [0], [0], [0], [0]

The ARM LED will then begin ashing to nofy that Installer mode has been entered.

Step 2

The menu structure is navigated by pressing the MENU key ( ) then the number key

corresponding to the required menu. Pressing the MENU key ( ) while navigang the menus or

changing opons will abort the current operaon and revert to the start of the menu tree.

The following pages will outline the menu selecons available.

Notes on Installer Access

If a module update has been performed on the system controller and the user code at system

controlleruserlocaon3(UN00003)hasbeenchanged.Thecodethatisenteredinthissengis

now the local Installer code. This code is programmed system wide when an update is performed.

TodisabletheInstallerCodeonallProtégé®EliteSuite®EclipseKeypads(recommended)deletethe

codeforUserUN00003byfollowingtheinstruconsintheEliteSuite®SystemReferenceManualfor

delengauserPINcode.

You can not access the installer menu if the EliteSuite® System is armed. Disarm the EliteSuite®

Systembeforeaempngtologinwiththeinstallercode.

Itisrecommendedthatallinstallermodicaonsarecompletedanddownloadedusingthe

Protégé®SystemManagementSuite(PRT-SMGT).Ensureamoduleupdatecommandisexecuted

whenmodicaonsarebeingmade.