Installation manual

The available opons are:
Opon 1 - Reserved
Opon 2 - Device Tamper
• Enabled, the device tamper switch is monitored.
• Disabled, the device tamper switch is not monitored.
Opon 3 to 8 - Reserved
Step 3
Pressing the ENTER key ( ) will save the opons. Pressing the MENU key ( ) will abort the
operaon without saving the opons.
9.4BacklightLevel(Menu3)
The brightness of the LED’s when not acve can be adjusted.
ToViewtheCurrentBacklightSeng
Step 1
To view the current Backlight seng enter the following key press sequence:
, 3,
The current Backlight seng will be displayed as a sequence of three Number LED’s lighng one
aer the other corresponding to each of the three digits of the seng.
ToChangetheCurrentBacklightSeng
Step 1
To change the current backlight seng enter the following key press sequence:
, 3, [SETTING 1], [SETTING 2], [SETTING 3],
The device will beep four mes to indicate that it has changed the Backlight seng. Note that
the highest value that can be assigned is 015.
!
All three digits must be entered when programming a Backlight seng. This means
that for a seng below 100, you must enter [0] then the 2 digits of the seng.
For sengs below 10, you must enter [0] , [0] followed by the seng digit.
18