Installation manual

9.2AddressSelecon(Menu1)

The Address Selecon sets the address of the Protégé® EliteSuite® Eclipse LED Keypad, this address

must be a unique address on the system from 1 to 250.

To View the Current Address

Step 1

To view the current address enter the following key press sequence:

, 1,

The address will be displayed as a sequence of three Number LED’s lighng one aer the other

corresponding to each of the three digits of the address.

To Change the Current Address

Step 1

To change the current address enter following key press sequence:

, 1, [ADDRESS 1], [ADDRESS 2], [ADDRESS 3],

The device will beep four mes to indicate that it has changed the address.

All three digits must be entered when programming an address. This means that

for addresses below 100, you must enter [0] then the 2 digits of the address.

For addresses below 10, you must enter [0], [0] followed by the address digit.

9.3DeviceOpons(Menu2)

The Device Opons set opons that relate to the mode of operaon of the Protégé® EliteSuite®

Eclipse LED Keypad.

Step 1

To enter the Device Opons menu enter the following key press sequence:

, 2

The currently assigned Device Opons will be displayed using the Number LED’s.

Step 2

To toggle opons press the keys 1 to 8 and the corresponding key LED will be lit when that opon

is ENABLED.