Installation manual

Step 1

To gain access to the Device Conguraon menu, apply power to the device.

Step 2

Within the rst two seconds aer the four beep tone is heard, press the CLEAR key ( ), followed

by the ENTER key ( ). Note: If any key is held down while the device is powered up it

will not be registered.

The ARM LED will then begin ashing to nofy that Device Conguraon mode has been entered.

You can then press the key corresponding to the menu required (asdetailedinthefollowing

secons).

9.0 Device Conguraon

9.1EnteringDeviceConguraonMode

Before the Protégé® EliteSuite® Eclipse LED Keypad module will communicate it must be assigned

an address and programmed with specic opons as to how it will operate. This is achieved by

accessing the Device Conguraon menu.

The Device Conguraon menu can only be accessed in the rst two seconds when

the device powers up. It is not able to be accessed when the system is operaonal.