Installation manual

5.0 Programmable Output
The Protégé® EliteSuite® Eclipse LED Keypad uses a Programmable Output (PGM) that will acvate
during an alarm condion. This Output can be programmed to either:
• Follow the status of the alarm siren me or the Fire alarm seng.
• Follow the armed/disarmed status of the keypad.
Connect a relay or other interface device to this open collector output for acvaon of
ancillary devices. The behaviour of this Output can also be inverted in the programming. Refer to
theGeneralOponssecononpage23fordetailsonPGMprogramming.
!
The PGM Output of the Protégé® EliteSuite® Eclipse LED Keypad is designed for
a maximum current of 100mA. If using it to trigger an external siren then a relay
must be used.
LED
PGM 1
+12V
RED
BROWN
Figure 12 - LED Example
Figure 11 - Programmable Output
BROWN
BLACK
PGM 1
0V
10