Installation manual

4.3 Zone Input Wiring

The Protégé® EliteSuite® Eclipse LED Keypad is capable of connecng to 8 zone inputs, each zone

input can then be programmed to perform the required funcon in the system.

The following diagrams show each of the zone wiring conguraon sengs that are possible.

The programmed zone conguraon for the Protégé® EliteSuite® Eclipse LED Keypad is made in the

opon sengs. RefertotheGeneralOponssecononpage23forprogrammingofthezone

conguraon.

When using a tamper input on a device the tamper contacts must be normally

closed and wired in series.

All resistors required to wire the zone conguraons are provided with the

Protégé® EliteSuite® Eclipse LED Keypad in the accessory bag.

Figure 5 - Zone Input (No Resistors)

Figure 4 - Zone Input (No Resistors)

Zone 1 (1+2)

Zone 1

N.C. Zone Contact

Zone 2

N.C. Zone Contact

Zone 2 (3+4)

PURPLE

ORANGE

BLACK

Zone 3

N.C. Zone Contact

Zone 4

N.C. Zone Contact

Zone 4

YELLOW

GREEN

GREY