Manualshelf

Installation Guide

ManualsBrandsProtecto Wrap ManualsKitchen6 in. x 15 ft. Form Flashing 2 EPDM
12
TECHNICAL DATA SHEET
Protecto Form Flash 2 EPDM™
Conformable Air/Vapor Barrier Tape
TECHNICAL DATA
Properties
Test Method
Test Results
Color
Black
Thickness
60 mil
Tensile Strength
ASTM D412
125 psi
Elongation (adhesive only)
ASTM D412
>500%
Permeance
ASTM E96
0.1 perm max
PACKAGING
Roll Width: 4”, 6”
Roll Length: 15’
Description
Protecto Form Flash 2 EPDM is a cold applied self-adhering membrane composed of uncured EPDM
with an exterior protective film on one side and a layer of Recycled Butyl Adhesive with a release liner on
the other side.
Features
- Rated for full exposure to UV
- Fully adhered system
- Seals around properly installed fasteners
- Roofs a positive air/vapor barrier
- Conformable to irregular shapes
- Will adhere to most building products
- Compatible with most building products including EPDM
Uses
Protecto Form Flash 2 EPDM is used to seal around cable, electrical, gas line, hose bibs, dryer vents,
air exchange vents and pipe penetrations in the exterior sheathing, roofing applications, CMU and Poured
in Place Concrete. Eliminates the need for Lead flashings, can be used at all roof to wall transitions,
around chimneys and solar panels.
Limitations
Not recommended in high temperature applications which exceed 300°F.
Shelf Life
Protecto Form Flash 2 EPDM maintains optimum initial adhesion to substrates when used within one
year from the date of manufacture.
Storage
Protecto Form Flash 2 EPDM should be stored in the original, unopened container at ambient
temperatures between 5 - 32°C (40-90°F). Storage area should remain dry and out of direct sunlight. Do
not remove materials from original containers until ready for use. Do not double stack pallets.
Preparation
Surface shall be clean, dry and free of any foreign materials. The surface shall be free of gaps, sharp
edges and protrusions.
Metal surfaces may need to be wiped with a double rag wipe, first rag with solvent to remove dirt or
contaminates and second dry rag to remove any solvent or residue, and/or abraded to achieve optimum
adhesion.

Summary of content (2 pages)