Operating instructions

Output Signals and Operation Restrictions When a Camcorder System is Configured (in HD Mode Only)
178
Appendix
The table below shows output signals from the camcorder and operation restrictions to the camcorder
when it is connected with a camera adaptor and camera control unit to configure a shooting and recording
system.
When the camcorder is equipped with the CA-FB70/CA-TX70 HD Camera Adaptor, full HD signals
complying with the HD-SDI standard are transferred to the camera adaptor.
Note
When configuring a camcorder system with a camera adaptor and camera control unit, install the optional CBK-CE01 50
Pin Interface and Digital Extender and set “OPERATION” > “Format” > “HD/SD” to “HD” in the setup menu.
a) PsF output
b) PD output
Output Signals and Operation Restrictions When a
Camcorder System is Configured (in HD Mode Only)
Settings of Rec Format and
System Frequency under
OPERATION >Format in
the setup menu
SDI outputs to the camera
adaptor
System format of
the camera adaptor
and camera control
unit
Operation restrictions to
the camcorder
Genlock Return video
display
HQ1920/59.94i 1920×1080/59.94i 1920×1080/59.94i Available Available
HQ1440/59.94i
SP1440/59.94i
HQ1920/29.97P 1920×1080/29.97PsF
HQ1440/29.97P
SP1440/23.98P 1920×1080/59.94i (2-3PD)
HQ1920/23.98P
a)
Output disabled Not supported Unavailable Unavailable
HQ1920/23.98P
b)
1920×1080/59.94i (2-3PD) 1920×1080/59.94i Available Unavailable
HQ1440/23.98P
a)
Output disabled Not supported Unavailable Unavailable
HQ1440/23.98P
b)
1920×1080/59.94i (2-3PD) 1920×1080/59.94i Available Unavailable
HQ1920/50i 1920×1080/50i 1920×1080/50i Available Available
HQ1440/50i
SP1440/50i
HQ1920/25P 1920×1080/25PsF
HQ1440/25P
HQ1280/59.94P 1280×720/59.94P 1920×1080/59.94i Available Available
HQ1280/50P 1280×720/50P 1920×1080/50i Available Available