Specifications

FEATURES & BENEFITS
1/15 to 1 Hp
Dual SCR Chassis
5
0
n Ability to control two different DC motors at once: Jumper selectable independent or speed ratio mode.
n MM footprint: An extremely compact chassis in an industry standard mounting footprint.
n Speed range and regulation: 1% over 60:1 speed range.
n User adjustable calibration pots: Two each of minimum speed, maximum speed, IR compensation, current limit and
acceleration/deceleration
n Stopping modes: Decelerate or coast (jumper selectable) using inhibit function (N.0.)
n Spade terminals: Allows for quick and easy terminations and changes.
n Panel space saving: Replace two DC drives with one compact package.
n Speed or Torque mode: Jumper selectable. Speed mode regulates speed and limits current. Torque mode regulates current
and limits speed.
n Microprocessor based: Can custom program the trimmer pot ranges and inhibit for OEM applications.
n Options & Accessories: Heatsink 223-0159. Pot kit with connector 202-0112 (M2 ships with two pot kits included).
M2 Series
Typical Applications
n Conveyors
n Material Handling
Machinery
n Packaging Machinery
n Sorting Machinery
n Packaging
n Printing Machinery
For matching DC motors, see pages 37 to 43.
M2 Series Specifications
*Heatsink 223-0159 is required whenever one side is more than 5A or the total of both sides is more than 6.5A
M2 w/o heatsink
115 VAC
0-90
5*
10
1/15 - 1/2
5/8
1.37
1.37
1/15 - 1
6.5*
11.5
1 1/8
0-90
115 VAC
M2 w/heatsink
Models
Input Voltage ±10%,
1 phase, 50/60Hz
(AC/DC)
Max. Cont. out-
put for each side
(Amps)
Max TOTAL
output of both
sides (Amps)
Hp Rating
for each side
Output Voltage
(VDC)
Max TOTAL Hp rat-
ing of both sides
Form
Factor
M2
The M2 drive provides the power of two drives in one! Now with one DC drive, you can control two different DC motors either indepen-
dently or in a ratio mode. In independent mode, each side of the M2 can be controlled differently with different trimmer pot settings and
different speeds. In speed ratio mode, one speed potentiometer sets the main speed while the other one determines the ratio of the speeds
between the motors. In this mode, the drive replaces two single drives and possibly a separate master/follower card resulting in extreme
cost and panel space savings!
The M2 drive is easy to set up with simple jumpers to choose the modes speed/torque, independent/ratio and coast/decel to stop. In
speed mode where speed is controlled, the external potentiometer sets the speed reference signal and the current limit trimmer pot sets the
current limit. In torque mode, the external potentiometer sets the torque reference and the current limit trimmer pot sets the runaway speed
limit.
Set up parameters are easily adjusted with on board trimmer pots. For OEMs that have fixed settings, the M2 drive is microprocessor based
and can have the settings or ranges of the trimmer pots and other functions customized without any hardware changes!
The M2 drive is ideal for applications with two DC motors that are working together, two motors that run independently but are physical-
ly close, or simply when panel space is very limited.
M2 Dimensions
For matching DC motors, see pages 37 to 43.
Call us toll free 1•800•MINARIK or download manuals at www.minarikdrives.com
A
SCR DRIVES