Specifications

FEATURES & BENEFITS
Rated for 5A (1/2 hp) with 115 VAC input and 10A (1hp) with the addition of
an optional heat sink, the M1 can fit where other drives with the same current
ratings can’t! The very compact M1 has a footprint of only 4.30” x 2.64” while
conveniently maintaining the industry standard for mounting hole location.
The programmable chip on the M1 sets ranges for the acceleration, decelera-
tion, current limit, and IR comp trimmer pots, eliminating the need of costly
hardware changes for OEM applications. Other features include the inhibit
function (connect via 2-pin header or via spade lugs) and a jumper to set for
use with smaller motors (1/15 to 1/8 hp). The M1 also has a wider (than typ-
ical) IR comp range for finer motor tuning and a safety feature: after any motor
stall, the M1 will follow the acceleration ramp setting to set speed instead of
ramping up at an uncontrolled rate.
With its compact size, standard features, programmability, and 1% speed regu-
lation, the M1 is excellent for both OEMs and users that require power and per-
formance in an extremely small package.
n Compact size: Gold extruded chassis with “MM” mounting hole locations with only a 4.30" x 2.64" footprint.
n Speed range and regulation: 1% regulation over 60:1 speed range.
n User adjustable calibration pots: IR compensation, max speed, min speed, acceleration, deceleration and torque.
n Stopping modes: The user can coast the motor to a stop (N.O.).
n Spade terminals: Easy to use, lower cost and able to fit in a smaller package.
n Two choices for inhibit connection: Remote start/stop control with cable and plug assembly (P/N 201-0024) or simply
connect to spade terminals.
n Programmable trimmer pot ranges: Unique application requirements for acceleration, deceleration, current limit and IR
compensation can be programmed into a chip without expensive hardware changes.
n Additional features: Wider than typical IR comp range for finer tuning, wide accel/decel range (.5 to 26 secs), and
vibration tested to 1G.
4
0
M1 Series
M1
1/15 to 1 Hp
SCR DC
* M1 Series drives require an additional heat sink (p/n 223-0159) when continuous armature current is above 5 ADC.
M1 Series Specifications
M1 without
heatsink
M1 with
heatsink*
115
115
0-90
0-90
1/2 - 1 @ 90 VDC
1/15 - 1/2 @ 90 VDC
5
1.37
10*
Max Output
Current (ADC)
Output Voltage
(VDC)
Input Voltage (VAC)
Form
Factor
Hp Rating
1.37
Typical Applications
M1 Dimensions
For matching DC motors, see pages 37 to 43.
All dimensions in inches [millimeters]
Models
n Conveyors
n Pumps
n Packaging Equipment
n Printers
n Industrial and
Commercial Machinery
Call us toll free 1•800•MINARIK or download manuals at www.minarikdrives.com
A
SCR DRIVES