Specifications

3
3
FEATURES & BENEFITS
1/20 to 1.5 Hp
PWM DC Regen
Typical Applications
n 2Q operation: Unidirectional operation with reverse torque capability for braking or combating over-hauling loads.
n Speed range and regulation: 1% regulation over 100:1 speed range.
n User adjustable calibration pots: IR compensation, min speed, max speed, accel, decel, forward current limit, and
brake current limit.
n Diagnostic LEDs: LEDs for power, motoring, and regen (torque or braking).
n Stopping modes: User can decelerate (N.O.), regeneratively brake (N.O.) or coast the motor to a stop (N.O.).
n Inhibit personality switch: Choose whether you brake or coast to a stop. Order inhibit plug with 18” leads
(201-0024) to use inhibit.
n Spade terminals: Easy to use, lower cost, and able to fit in a smaller package.
n Auto-ranging power supply: Can accept 90-240VAC or an 80-340 VDC input. Connections will vary.
The NRG-2Q Series, is easy to use, and at the same time, will sat-
isfy demanding application requirements. In addition to on-board
fusing to protect your motor and drive, the NRG will accept any AC
input voltage between 90 and 240 VAC at 50 or 60Hz. With an
auto-ranging power supply there are no switches to set, no settings
to change. The NRG-2Q will also accept any DC voltage between
80 and 340 VDC (consult factory for other input voltages).
These highly efficient, near unity form factor PWM regenerative dri-
ves will increase motor performance while reducing your energy
costs. MOSFET power in PWM drives switch at 16kHz, to provide
fast circuit response and the constant 1.05 (pure DC is 1.00) form
factor throughout the entire 100:1 speed range.
The NRG-2Q will work with isolated logic signals, motion con-
trollers, and programmable logic controllers. It is also compatible
with Minarik’s popular PCM4 signal isolator and DLC600 digital
controller. Contact factory for connections.
NRG-2Q
NRG-2Q Series
n Elevated Conveying
n Printing
n Exercise Equipment
n Film Processing
n Winding Machinery
Models
Output Voltage
(VDC)
Max. Output
Current (ADC)
NRG2Q Series Specifications
Models
Input Voltage
(AC/DC)
Output Voltage
(VDC)
Max. Output
Current (ADC)
Hp Rating
Height (A)
NRG02-D240AC-2Q
90-240
0–130/0–240
2
2.62”
2.62”
2.43”
1/20 – 1/4 or 1/10 – 1/2
1/8 – 3/4 or 1/4 – 1.5
1/4 - 1.5
5
10
Form
Factor
1.05
1.05
1.05
0–130/0–240
0-130
90-240
90-120
NRG05-D240AC-2Q
NRG10-115AC-2Q
*Some applications may require shunt resistor. Please consult factory for sizing information. Drives operate from 50 - 60 Hz.
NRG Dimensions
All dimensions in inches [millimeters]
All dimensions in inches [millimeters]. See table above for height “A”
For matching DC motors, see pages 37 to 48.
Call us toll free 1•800•MINARIK or download manuals at www.minarikdrives.com
C
REGENERATIVE DRIVES