Technical data

ABS warning light lights up.
with automatic Stability Con-
trol
OE
First the ASC symbol changes
its display behavior. Press
and hold button 1 until ABS
warning light reacts. In this
case, the ASC setting does
not change.
Release button 1 within two
seconds.
ABS warning light contin-
ues to light up.
ABS function is deactivated,
integral function continues to
be active.
Switching on ABS
function
Press and hold button 1 until
ABS warning light changes its
display behavior.
ABS warning light goes
out; if self-diagnosis has
not been completed, it begins to
flash.
Release button 1 within two
seconds.
ABS warning light remains
off or continues to flash.
ABS function is switched on.
As an alternative, the ignition
can also be switched off and
then on again.
If the ABS light continues
to light up after switching
the ignition off and then on again,
an ABS fault has occurred.
ASC Automatic
Stability Control
with automatic Stability Con-
trol
OE
Deactivating ASC function
Switch on ignition.
The ASC function can
also be deactivated while
driving.
4
49
z Operation