Technical data

Push rear wheel stand from left
into rear axle.
Mount lock washer 2 from right
by pressing release button.
Position motorcycle upright
while simultaneously pressing
grip of stand back so that both
stand rollers rest on ground.
Then press the grip down to
the ground.
To ensure a secure position,
install lever 4 on the short side
of the stand.
Lamps
Replacing low-beam and
high-beam bulbs
The alignment of the con-
nector may differ from the
illustration depending on the bulb
to be replaced.
Make sure the ground is level
and firm and park the motorcy-
cle.
Switch off the ignition.
Remove the covers 1 on the
high-beam bulbs and/or the
cover 2 on the low-beam bulbs
by turning counterclockwise.
8
105
z Maintenance