Technical data

Install securing screws 2 on left
and right with specified torque.
Front brake caliper on
wheel carrier
22 lb/ft (30 Nm)
with BMW Motorrad Integral
ABS Generation II
OE
The cable of the wheel
speed sensor could chafe
through if it comes into contact
with the brake disk.
Make sure that sensor cable is
routed correctly.
Snap the two retaining clips 1
for the sensor wire onto the
brake line.
Remove adhesive tape from
wheel rim.
Press handbrake lever firmly
a number of times until resis-
tance point is noticeable.
Position cover panels 2 on left
and right.
Install screws 1 on left and
right.
Removing rear wheel
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear
wheel stand.
Installing rear-wheel stand
( 104).
8
99
z Maintenance