Service manual

SECTION 5 - JLG CONTROL SYSTEM
5-6 – JLG Lift– 3121122
5.3 FLASH CODES/DTC’S AND DESCRIPTIONS
NOTE: Machines with software prior to P1.0 will display the
Flash Code on the JLG Analyzer as shown below.
The 2 digit Flash Code is scrolled at the end of the
Help Message. Refer to "Flash Code" column of
Table 5-1.
NOTE: Diagnostic Trouble Codes (DTC’s) will only show for
machines with software P1.0 and above. The 3 to 5
digit DTC will display in parenthesis on the JLG Ana-
lyzer in the upper right corner of the display screen
as shown below. Refer to Table 5-1 for DTC’s.
hel p:
ng change (2/2).
FLASH
CODE
hel p: (001)
ever yt hing ok
DTC
Table 5-1. Flash Codes/DTC’s
FLASH CODE DTC HELP MESSAGE AND DESCRIPTION
No Flash
Code
000 HELP COMMENT
001 EVERYTHING OK
The normal help message in Plaform Mode.
002 GROUND MODE OK
The normal help message in Ground Mode.
0022 DIFFERENT FUNCTION SELECTED & IGNORED
A function (i.e. Drive, Lift, etc.) is active and the operator has selected another function. The system has ignored the new selec-
tion.
0023 FUNCTION SELECTED BUT TRIGGER SWITCH OPEN
A function (i.e. Drive, Lift, etc.) has been selected by the operator, but the trigger switch is not active (closed).
0024 JOYSTICK MOVED BUT NO FUNCTION SELECTED
The joystick was moved out of the center position before a function was selected.
0025 ALARM SOUNDING - PLATFORM OVERLOADED
Load Sensing System indicates that the platform is overloaded. Applicable when Machine Setup’s Load is set to "1 = CUTOUT
PLT" and the vehicle is operating in Ground Mode.
003 ALARM SOUNDING - TILTED & ABOVE ELEVATION
Platform is elevated and the chassis is not level. Applicable when Machine Setup’s TILT CUTOUT is set to 0 = NO.
004 DRIVING AT CUTBACK - ABOVE ELEVATION
Platform is elevated and the machine is in the drive mode of operation.
005 DRIVE & LIFT UP PREVENTED - TILTED & ELEVATED
Machine is exceeding tilt allowance and platform is elevated above allowed height. Applicable when Machine Setup’s TILT
CUTOUT is set to 1 = YES.
009 DRIVE PREVENTED - ELEVATED ABOVE DRIVE CUTOUT HEIGHT
Machin is elevated above the drive cutout height. Not applicable when Machine Setup’s MODEL is set to 0 = 3369LE.