Owner`s manual

30
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONSINDEX
DASHBOARD
AND
CONTROLS
CORRECT USE
OF THE CAR
Automatic headlight daylight
sensor (Light Sens.)
(for versions/markets, where provided)
With this function it is possible to adjust
the light sensor sensitivity according to
3 levels.
To adjust the volume proceed as follows:
❒ briefly press button MENU: the pre-
viously set level will be displayed;
❒ press button + or – for setting as re-
quired;
❒ briefly press button MENU to go
back to the menu screen or press the
button for long to go back to the
standard screen.
Reset Trip B (Reset Trip B)
This function enables to select Trip B re-
set mode (Automatic or Manual).
For further information see paragraph
“Trip computer”.
Speed limit (Speed limit)
With this function it is possible to set the
car speed limit (km/h or mph), which,
if exceeded, automatically sounds a
buzzer and displays a special message
(see section “Warning lights and mes-
sages”) to alert the driver.
To set the speed limit, proceed as fol-
lows:
❒ briefly press button MENU: OFF
will be displayed;
❒ press button +: ON will be dis-
played;
❒ briefly press button MENU then,
use buttons +/– to set the required
speed (during setting the value will
flash).
❒ briefly press button MENU to go
back to the menu screen or press the
button for long to go back to the
standard screen.
IMPORTANT The possible setting is
between 30 and 250 km/h (or be-
tween 20 and 150 mph) depending on
the unit set previously (see paragraph
“Units” described later). Every press
(pulse) of the button +/– increases or
decreases the value by 5 units. Keeping
the button +/– pressed obtains auto-
matic fast increase or decrease. When
you are near the required setting com-
plete adjustment with single presses.
To abort the setting:
❒ briefly press button MENU: ON
will be displayed;
❒ press button –: OFF will be dis-
played;
❒ briefly press button MENU to go
back to the menu screen or press the
button for long to go back to the
standard screen.