Owner`s manual

171
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX DASHBOARD
AND
CONTROLS
CORRECT USE
OF THE CAR
❒ refit the space-saver spare wheel
making the rim holes coincide with
the wheel hub holes
❒ Using the wrench provided, fully
tighten the five fastening bolts;
❒ Lower the car and remove the jack;
❒ Use the wrench provided to fasten
the bolts completely in a criss-cross
fashion according to the sequence
shown in fig. 8.
REFITTING A NORMAL
WHEEL
Following the procedure described pre-
viously, raise the car and remove the
spare wheel.
Proceed as follows:
❒ tighten pin A-fig. 9 in one of the
holes of the wheel hub fastening
bolts;
❒ insert the wheel on the pin and, us-
ing the wrench provided, tighten the
four bolts available;
❒ loosen pin A-fig. 9 and tighten the
last fastening bolt;
❒ lower the car and remove the jack,
then, using the wrench provided tight-
en the bolts according to the sequence
previously shown for the space-saver
spare wheel fig. 8.
A0G0210m
fig. 8
A0G0211m
fig. 9
When you have finished:
❒ Stow the spare wheel in the space
provided in the boot;
❒ Fit the jack partially open in its con-
tainer forcing it lightly to prevent it
from vibrating when travelling;
❒ Put the tools back into their places
in the container;
❒ Arrange the container complete with
tools on the space-saver spare wheel;
❒ Reposition properly the boot stiff cov-
ering.