User Manual

www.pro-team.com 866.888.2168 42
Troubleshooting
1.
2.
3.
4.
5.
6.
CLEARING HOSE AND WAND OBSTRUCTIONS – HEPA MODELS
R
E
S
E
T
R
E
S
E
T
Figure A
Figure C
Port
Lower air duct
Guide
Figure D
Figure B
1.
2.
3.
CLEARING THE BRUSH ROLL
Obstructions such as hair, string, and throw rugs may cause the red brush
indicator light to be illuminated and the power nozzle to shut off.
Turn off vacuum and unplug power cord from outlet.
On underside of vacuum, pull out, or cut away, obstructions on the
brush roll. (Figure A).
Press the reset button on top side of powerhead. Plug-in power cord,
and restart motor. (Figure A).
CLEARING HOSE & WAND
Obstructions in hoses and wands may reduce or eliminate suction.
Turn off vacuum and unplug power cord from outlet
Open Bag Housing Cover (Figure B) and replace Intercept Micro Filter. A
full filter will restrict airflow.
Disconnect the lower air duct hose on the back of the power nozzle
(Figure C). Visually check the lower air duct hose for debris and remove.
To check for unobstructed air flow, turn on vacuum with bag housing
cover closed and place hand over opening on lower air duct (Figure C). If
you feel prope suction, reconnect lower air duct and resume vacuuming.
If blockage is not in lower air duct hose, proceed to step 5.
Carefully insert a broom handle (or any similar item like a short length of
hose, pipe, etc ) approximately 14 inches into guide on top of vacuum
housing (Figure D) to dislodge obstruction or debris. Debris should then
drop or move into the lower air duct where you can then remove it with
your hand.
Reconnect the lower air duct and upper hose assembly. Close bag hous-
ing cover and power on the vacuum.