Instructions / Assembly

www.pro-team.com 866.888.2168 24
Motor
REMOVING CARBON BRUSHES
INSTALLING CARBON BRUSHES
Remove both locking connec-
tors with small flat tip screw-
driver. Press brass tab (inside
bracket) down so it is flush
with brush.
2.
Disconnect wire from carbon
brush.
1.
Using pliers (or fingers), carefully
grasp tab and remove carbon
brush from bracket
3.
Carefully bend brass tab slightly
upward with small flat tip
screwdriver.
2.
Re-connect wire. Replace
locking tabs. Bend tabs
downward.
3.
Insert carbon brush into
bracket.
1.