Instructions / Assembly

www.pro-team.com 866.888.2168 20
Wire Harness
WIRE HARNESS REPLACEMENT (CONTINUED FROM PAGE 19)
Replace sound foam and install the motor mount.
16.
Pull wires up through housing – one on each side.
18.
Reinstall bag lockout switch.
19.
17.
Tuck wires below bulkhead, leaving the bag full
indicator tube out to insert into the bulkhead as
shown. If the bulkhead does not seat firmly onto
the motor housing, you must adjust the motor
until the motor is properly installed.
(Continued on page 21)