Operation Manual

Important Notice:

• NEVER OPERATE THIS MACHINE WHEN THE AMBIENT ROOM AIR TEMPERATURE IS

GREATER THAN 90 DEGREES FAHRENHEIT.

• NEVER OPERATE THIS MACHINE IN A COMMERCIAL APPLICATION WHEN THE REMOTE

TIMER IS NOT WORKING PROPERLY.

• NEVER OPERATE THIS MACHINE WHEN THE BLUE FILTER GLASS IN ANY FACIAL

TANNER IS NOT INSTALLED OR IS BROKEN / DEFECTIVE.

• NEVER OPERATE THIS MACHINE WHEN IT IS NOT VENTILATING ITSELF PROPERLY (TOO

HOT INSIDE).

• THE SALON OWNER OR OPERATOR MAY NEVER, UNDER ANY CIRCUMSTANCES, OPEN THE

BENCH OR CANOPY OF PROSUN UNITS WITHOUT THE SUPERVISION OF AN AUTHORIZED

SERVICE PERSON.

CAUTION: Please refer to your individual bed for the recom-

mended tanning schedule and proper

exposure times for the model that you have purchased.

The Electrical requirements for you tanning bed are:

Model breaker 3~ breaker 1~ volt 3~ Volt 1~ Hertz Operating

Amps3~

Operating

Amps1~

X7 42 H Int. 40 Amp 60 Amp 3x220V 220V 60Hz 30-35 50-55

X7 38 H Int. 40 Amp 60 Amp 3x220V 220V 60Hz 24-29 46-52

X7 38 Int 40 Amp 60 Amp 3x220V 220V 60Hz 22-25 44-50

V5 H Int. 40 Amp 50 Amp 3x220V 220V 60Hz 26-30 41-46

X5 34 Sli. 30 Amp 50 Amp 3x220V 220V 60Hz 25-27 40-43

X5 34 Spr 30 Amp 50 Amp 3x220V 220V 60Hz 23-25 38-42

Operating any 220 Volt combination at voltage levels below 210 Volts

or above 230 Volts constitutes an automatic NULLIFICATION of the

ProSun factory warranty, because it could cause damage to the unit’s

system.

Please insure that your electrician and/or installer, reads this user’s

manual carefully prior to the installation of your tanning bed.

WARNING:ALWAYS DISCONNECT THE TANNING BED

FROM ITS POWER SUPPLY WHEN SERVICING

OR REPAIRING THE UNIT.