Operation Manual

Controls

The default settings for the sun bed are for use with an external timer or for coin-operated use. If the

sun bed is used without an external timer or not coin-operated, and the internal timer needs to function,

the required tanning time should be set following the procedure described below.

Keep the “conﬁ g” and the “increase body cooling” buttons pressed simultaneously for 10 seconds.

After 10 seconds, the display will show “SET 20”.

Pressing the “increase body cooling” button means the tanning time can be increased (max. 30

minutes)

Pressing the “decrease body cooling” button means the tanning time can be decreased.

Pressing the “start” button will conﬁ rm the setting.

If the controls have been set for use with an external timer or coin-operated use, the display will

show an “A” after conﬁ rmation.

If the controls have been set for use with an internal timer, the display will show an “H” after

conﬁ rmation.

The sun bed will be started automatically if the external timer or coin-operated equipment

does not have a “remote start”. If there is a “remote start”, the sun bed must be started by

pressing the “start” button.

Note:

If the sun bed has an external timer or is coin-operated and does not have a “remote start”

function, but should be started by using the “start” button, your dealer will be able to set this

for you.

The equipment will pause when the “stop” button is pressed once. If stop is pressed more than

once, the equipment will remain paused. The sun bed will not stop until the tanning time is up.

Note:

A. If the sun bed is restarted within 3 minutes after stop has been pressed, it is possible

that the face tanners do not switch on.These need to cool down for at least 3 minutes,

after which they will switch on again automatically.

B. If the “stop” button is pressed, the airco will switch off after a 5 minute delay. Fol

lowing these 5 minutes, the airco also has a cooling down period of 3 minutes.

C. The tanning time will count up.

Decrease body cooling Increase body cooling

Config. Increase body cooling

Start

Note:

A. If it is necessary to cancel the conﬁ guration, please press the “stop” button.

B. If no settings are entered for a time span of 30 seconds, the controls will be reset to

their original state.

C. A = automatic, H = manual

D. When an external timer is used or for coin-operated use, the tanning time must be set to 0 minutes.

Controls in combination with an external timer or for coin-operated use:

General

Start

Stop