Operation Manual

ProSun Sunshower use:
PROSUN SUNSHOWER OPERATION > HOME USE (See operating panel page 1)
How do I start a standard full body session?
· Press the START button (G): the operating panel is activated.
· Press the START button (G) again: all lamps are switched on for ten minutes.
How do I start a personalised session?
· Press the START button (G): the operating panel is activated.
· Change time: select the length of the treatment (maximum 15 min) by pressing the + button (F) or
the – button (E). The time can also be changed during the treatment.
· Lamp choices: the keys (I,J,K,L) on the operating panel correspond with the HPA lamps. All fi ve
are turned on as standard. If you want to determine which arrangement of HPA lamps come on,
turn them on or off by pressing the corresponding lamp keys (I,J,K,L). You cannot change your
desired arrangement again during your tanning session. The lowest key (L) operates the lowest two
lamps.
· Press the START button (G) again: the selected lamps are switched on during the time set.
What can I change during the tanning session?
· During tanning, you can change the tanning time to a maximum of 15 minutes.
· The ProSun Sunshower will give a signal one minute before the end of the tanning session, so that
you can change the tanning time if required.
· You cannot change the selected lamp combination during tanning.
What happens after the ProSun Sunshower is turned off?
· The Sunshower will cool down for three minutes after it has been turned off before it can be used
again (cool down symbol (N) illuminated).
· If the “cool down” symbol is illuminated (N) on the operating panel, the
Sunshower is cooling down (three minutes post-cooling time). The ProSun Sunshower cannot be
used during the post-cooling period.
How do I stop the ProSun Sunshower before the end of the session?
· The treatment fi nishes prematurely when you press the STOP button (H). Then the Sunshower
automatically cools down for three minutes (“cool down” symbol (N) illuminated).
Page 10