ProSun SunShower 15 Minute User Manual ProSun International, LLC 2442 23rd Street North, St. Petersburg Florida 800-874-2776 Ph. 727-825-0400 Fax 727-825-0700 E-mail sales@prosun.
Table of contents Table of contents / Serial number.......................... Warning / Exposure stickers................................. General Discription.............................................. Introduction....................................................... Important safety instructions................................ Important information on tanning conditions.......... How long and how often...................................... ProSun Sunshower use........................................
Page 3
D E M F N O I J K L C T D G H B A G clea lass ner Q P R A Carefter S Page 4
ENGLISH PROSUN SUNSHOWER COLOUR YOUR LIFE! Introduction CONGRATULATIONS! Congratulations with the purchase of your ProSun Sunshower. Experience the ultimate holiday feeling of sun and water in your own bathroom! Each of the five powerful UV high-pressure lamps, which are built into the wall, can be used separately. This ensures that each part of your body has the right amount of tanning while you enjoy a relaxing shower. The average shower time (of ten minutes a day) is enough to produce a healthy tan.
Important safety instructions Installation · Each ProSun Sunshower must be connected to a dedicated 220 volt circuit that is protected with a 15A GFCI (ground fault circuit interupter) · Using the shower before the ProSun Sunshower has been installed is prohibited. · Ensure that the air inlet and outlet ventilator grills are free of obstacles. The system is fitted with an automatic safety against overheating. The system automatically turns itself off if cooling is insufficient (e.g.
Important information on tanning conditions What should I do before using the Sunshower? · Determine your skin type on the basis of your skin colour (see tanning table). · Do not expose yourself to excessive natural sunlight on the same day. · Allow an interval of at least 48 hours between the first and second session. · Remove creams, lipstick and other cosmetics from your skin well before the tanning sessions. · Do not expect the system to produce a better result than the sun.
Important information on tanning conditions What should one do after using the ProSun Sunshower? · You can apply a moisturising cream if your skin feels taught after a tanning session. · Dry yourself immediately if you want to continue tanning after showering. When can you not use the ProSun Sunshower? · Children under 16 may not use the ProSun Sunshower. · The ProSun Sunshower is not suitable for medical use.
The sun, tanning, how long and how often? The sun The sun produces various types of energy: visible light that allows us to see, ultraviolet (UV) light that tans our skin and infrared (IR) light that gives the sun’s rays the warmth that we enjoy. Tanning and your health Just as with normal sunlight, the tanning process with the ProSun Sunshower takes time. The first results are only visible after a few sessions.
ProSun Sunshower use: PROSUN SUNSHOWER OPERATION > HOME USE (See operating panel page 1) How do I start a standard full body session? · Press the START button (G): the operating panel is activated. · Press the START button (G) again: all lamps are switched on for ten minutes. How do I start a personalised session? · Press the START button (G): the operating panel is activated. · Change time: select the length of the treatment (maximum 15 min) by pressing the + button (F) or the – button (E).
Cleaning and maintenance of the ProSun Sunshower The front of the Sunshower is the only part that can be cleaned by the users: this includes the decorative frame (A), the coated glass (B) and the operating panel (C). Cleaning advice for the coated glass The glass plate (B) is treated with a special coating to reduce the risk of scale. Coated glass is a material that is not as prone to scratching as plastic, but it can nevertheless be scratched easily.
Replacing the lamps The UV output of the tanning lamps declines with time (this occurs under normal usage after a number of years). The lifespan of the Philips HPA Cleo Swift 250-500 is 600-800 hours. After 600 burning-hours, the LED displays corresponding to the lamps concerned on the operating panel (O) start to flicker after you press the start button (G).
Trouble shooting ERROR MESSAGES If the ProSun Sunshower does not function as it should or needs maintenance, two types of error message may appear on the display (M): 1. 2. Er + UI: Temperature / Glass closure error message LA + flickering lamps: the burning-hours have been exceeded 1.What do you do if Er + UI appear on the display (M)? This means that there is a temperature or glass closure error message. There is a problem. Check whether the air inlet/outlet opening in the other room is not blocked.
ProSun International,LLC. ® LIMITED WARRANTY EFFECTIVE July 1th, 2006 1. 2. 3. 4.
