Operation Manual

ELECTRICAL REQUIREMENTS
IMPORTANT NOTICE
Please carefully read the following information prior to connecting your tanning bed.
The electrical requirements for your new tanning bed are:
Operating any 220 Volt combination at voltage levels below 210 Volts or above 230 Volts
constitutes an automatic NULLIFICATION of the ProSun® factory warranty, because it
could cause damage to the unit’s system.
Please insure that your electrician and/or installer, reads this user’s manual carefully prior to
the installation of your tanning bed.
WARNING:
ALWAYS DISCONNECT THE TANNING BED
FROM ITS POWER SUPPLY WHEN SERVICING
OR REPAIRING THE UNIT.
3~ = Three Phase
1~ = Single Phase
M o d e l
4 8 X L c i n t
B r e a k e r
3 ~
4 0 A m p
B r e a k e r
1 ~
7 0 A m p
V o l t
3 ~
3 x 2 2 0 V
V o l t
1 ~
2 2 0 V
H e r t z
6 0 H z
O p e r a t i n g
A m p s 3 ~
3 2 A m p s
O p e r a t i n g
A m p s 1 ~
6 2 A m p s
L u m i n a V 4 8 X L c i n t e n s i v e