Operation Manual

13
REVISED: 11/20/01
REPLACEMENT OF COMPONENTS
WARNING: Before doing any repair or replacement work on this machine, ALWAYS
disconnect the power (or, if the main power cable has a wall plug, pull it out) at the main
circuit breaker.
Removal of the bench acrylic:
• Turn the plastic click strips on either side of the canopy downwards
• Remove the securing screw.
• Pull the acrylic sheet down and out of the canopy.
• Lower the acrylic sheet a little.
• Pull it out of the canopy.
Replace the acrylic sheet in the bench in the reverse manner.
Removal of the canopy acrylic:
• Same as the bench acrylic.
Lamp replacement:
Holding the lamp with both hands, turn it until the bi-pins can slide easily out of the lamp
holder socket, and slowly take it out of the unit. Clicks will be heard as the socket
incrementally rotates. Replace the lamp in just the opposite manner, making sure that the
labeling on the lamp itself is pointed outward. SEE WARNING LABEL FOR LAMP
TYPES.
Starter replacement:
Grasp and turn the starter to the left, one half turn until it comes easily out of the socket.
Replace the starter in the opposite manner.
IMPORTANT: ONLY USE MANUFACTURER - AUTHORIZED REPLACEMENT
COMPONENTS. FAILURE TO DO SO MAY VOID WARRANTY.