User manual

ES
ES-10
a) Insert the strap through the strap slots on the rear housing.
b) Wrap the strap around the mounting surface. Secure the strap and tighten the buckle in
order to secure the camera.
▲ In order to obtain proper weather resistance, please make sure that both door latches are
securely locked in place.
7.2 Turn on the Camera
Then, just turn on the power switch and the camera is ready to take pictures. When the PIR
sensor is trigged, it will start to take photos right after the delay time is passed.
7.3 Testing the camera coverage area
One of ProStalk Nature Camera’s features is the ability to test the coverage area.
• After mounting the camera, open the front housing and slide the “Power” switch to “ON”
position and press the "SETUP" button.
• A red indicator light on the front will blink when you have intruded the coverage area.
• Adjust the camera position as needed and repeat testing until the desired coverage area is
achieved.