User's Manual

9V�AC
300mA

  
 
 
Page 6
3 Connecting the WAHryTone
3.1 The Front Panel

Effect On LED
This LED lights up when the WAHryTone is operational. A blinking LED means that the device is running but not
connected to the app.

Antenna
The antenna is needed by the WAHryTone to communicate with the app.

Expression Pedal Connector
Here you can connect an expression pedal via mono jack cable or an expression pedal with switch via a stereo jack
cable. (see chapter 3.3).
3.2 The Rear Panel

Power Connector
The WAHryTone must be powered necessarily using a 9V~AC (alternating current!) power supply. The WAHry-
Tone will not work with direct current (DC). Higher voltages can destroy the WAHryTone.

MIDI In
Connect the [MIDI In] of the WAHryTone using a MIDI cable to the [MIDI Out] of the foot controller or the [MIDI
Out] of the Prostage XDS | XLS | XTMpro. If several MIDI effect devices are used, the [MIDI In] from the WAHryTone
can also be connected to the MIDI [Thru] of another device in your MIDI chain.

MIDI Out/Thru
All data received at the MIDI In are forwarded on the [MIDI Out/Thru]. You can connect e.g. other effects devices
or a MIDI-capable guitar amp to this connector. Further, MIDI data generated by the WAHryTone (e.g. Tuner data)
is also sent on the [MIDI Out/Thru].

Guitar In
Connect your Guitar to the [Guitar In] using a jack cable.

Guitar Out
Connect the [Guitar Out] to your guitar amplifier or the next effects unit, using a jack cable.