User's Manual

-15dB (MIDI 0)
1.0 (MIDI 0) 1.0 (MIDI 0)
-15dB (MIDI 0)
4.1dB (MIDI 127)
3.5 (MIDI 127) 3.5 (MIDI 127)
4.1dB (MIDI 127)
0
0
127 127
162 - 486 Hz (MIDI 0) 162 - 486 Hz (MIDI 0)
2.2 - 6.6 kHz (MIDI 127)
2.2 - 6.6 kHz (MIDI 127)
Page 21
8.2.3 WahWah Specific Parameters
Frequency (WahWah)
Controls the base frequency of the WahWah effect.
Input Gain
Adjusts the input gain of the WahWah effect. This value influences the drive of the Fasel coil. At high levels, a
compression effect will occur.
Q-Factor
The Q factor is the width of the WahWah filter. Low values result in a wide WahWah sound with only slightly low-
ered bass and treble. High values give a thin sound with strongly reduced bass and treble.
Coil Damping
[Coil Damping] controls the rating of the Fasel coil. Small values produce a flat effect. High values result in a sharp
WahWah effect.