Technical Specifications

Clean up
Clean tools and hands with warm soapy water immediately
after use and before material dries. Material is very difficult to
remove once dried.
Limitations
• Apply only to surfaces that are frost free and between 40°F-
90°F (4°C-32°C) within 24 hours of application and 72 hours
thereafter.
 Do not apply in direct sunlight on hot, windy days, or when
rain is expected within 24 hours.
 Do not apply fewer than two coats to ensure uniform and
minimum thickness.
 Do not bridge over existing expansion or control joints or
static, non-moving cracks greater than ⅛ in. (3 mm).
 Do not bridge over dynamic, moving cracks.
• Do not use where exposed to negative hydrostatic pressure.
 Initial set time is 1-1½ hours at 70°F (21°C)
 Drying time before stone veneer application is 1-1½ hours or
up to 12 hours.
 Store in the original unopened container, away from moisture
in cool, dry conditions. Product in container should not
freeze.
Note: Unprotected membrane should not be directly exposed to
sun or inclement weather prior to the installation of the finishing
veneer surface materials.
Coverage
 1 gal. (3.8 L) pail: Yields approximately 40 ft
2
( 3.7 m
2
),
coverage when applied 30 mil wet film (two-coat application
total yield per 1 gal. unit).
6. AVAILABILITY
To locate ProSpec
®
products in your area, please contact:
Phone: [phone]
Website: tccmaterials.com
7. WARRANTY
Seller warrants that its product will conform to and perform in
accordance with the product specifications. The foregoing
warranty is in lieu of all other warranties, expressed or implied,
including, but not limited to those concerning merchantability
and fitness for a particular purpose. Because of the difficulty in
ascertaining and measuring damages hereunder, it is agreed
that Seller’s liability to the Buyer shall not exceed the total
amount billed and billable to the Buyer for the product
hereunder.
8. MAINTENANCE
Not applicable.
9. TECHNICAL SERVICES
Technical Assistance:
Information is available by calling TCC Materials
®
(hours 7:30 AM to 4:00 PM, M-F, CST):
Phone: [phone]
Fax: [phone]
Web: tccmaterials.com
Technical and Safety Literature:
To acquire technical and safety literature, please visit our
website at: tccmaterials.com.
3
©
Copyright 2016 TCC Materials
®
Akona
®
Manufacturing, LLC, a TCC Materials
®
company, is a
licensed manufacturer of ProSpec
®
ProSpec
®
is a trademark of H.B. Fuller Construction Products Inc.
LEED
®
is a registered trademark of U.S. Green Building Council.
Data Sheets are subject to change without notice. For the latest
revision, check our website at tccmaterials.com
REV 03/16
2025 Centre Pointe Blvd, Suite 300,
Mendota Heights, MN 55120